Browsed by
Category: Motion Picture Film

16 MM Camera Lens Out Of Calibration? (#2)

16 MM Camera Lens Out Of Calibration? (#2)

This is the second in a series of posts.  The prior post can be found here: Student Asks, Was The Lens Out Of Calibration? (#1) https://ypw.wrq.mybluehost.me/website_12972da0/?p=1032 On 11/18/10 9:57 PM, “A. B.”  wrote: All this information is very useful and I have been told since emailing you many of the same things.  All these things are definitely key in my future filming.  I was told by another about the ground glass being specifically important as well.  Although I new about…

Read More Read More

Student Asks, Was The Lens Out Of Calibration? (#1)

Student Asks, Was The Lens Out Of Calibration? (#1)

This is the first in a series of e-mail posts. The next post can be found here: 16 MM Camera Lens Out Of Calibration? (#2) https://ypw.wrq.mybluehost.me/website_12972da0/?p=1035 On 11/16/10 7:43 PM, “A. B.” wrote: Hi I am a new filmmaker still in school and I recently read your blog from 3 years ago here https://ypw.wrq.mybluehost.me/website_12972da0/?p=196 My question is what if you have done all these steps and the feet marked with measuring tape are not matching up.  For instance my subject…

Read More Read More

Arriflex 16MM camera model S

Arriflex 16MM camera model S

Troubleshooting the obvious and less obvious: Camera will not run. Check to make sure the motor clamp is snug. The camera motor body is the return electrical path and must be touching the motor housing clamp tight enough for a good electrical contact. The film buckle switch might not have been set properly. Open the sprocket wheel mechanism and then close. You don’t see it but a little plunger resets the film buckle switch to the “ON” position by open…

Read More Read More

Verified by MonsterInsights